Keyence CV-X100 Series User Manual download pdf (Page 3)

햲 Parallel I/O connector

Use to connect the parallel input/output signals.

햳 SD2 slot (upper), SD1 slot (lower)

Insert an SD card.

The lower slot (SD1) holds the included SD Card (512 MB or 1 GB) by

factory default.

햴USB connector for dedicated mouse

Use to connect the included dedicated mouse.

햵 RGB output terminal

Use to connect to an external monitor.

햶 CAM2 connector

Use to connect camera 2.

햷 Expansion unit connector 1 (right side, only for CV-X150/X170)

Use to connect the camera expansion unit CV-E500.

햸 RS-232C connector

Use to connect to the RS-232C communication cable (OP-26487: 2.5 m,

sold separately).

햹 CAM1 connector

Use to connect camera 1.

햺 ETHERNET connector

Use to connect an Ethernet cable.

햻 Terminal Block

Use to connect the power supply (24 VDC) and the input/output signals.

햽 Grounding terminal

Use to connect the installation line.

햾 Expansion unit connector 2 (left side)

Use to connect the illumination expansion unit CA-DC10E, CA-DC21E, or

CA-DC30E.

Install the controller unit to DIN rail, or use the holes on the bottom of the

controller to secure it with screws.

Caution on Direction of Controller Mounting

• Install the controller in the direction indicated by the circle shown below.

Do not install the controller in any other direction.

• For ventilation, keep the space free of objects for 50 mm or more above

the controller and 50 mm or more for both sides. Keep the space free of

objects for 90 mm or more in the front of the connector panel in order to

connect the cables safely.

• When two or more controllers are installed side by side, maintain 50

mm or more of space between the controllers, and 50 mm or more

above both controllers.

Identifying Controls and Connectors

SD Card 1 must be inserted while the device is operating.

The USB port for the mouse of this device is used exclusively

for the dedicated mouse (OP-87506).

If other equipment including a commercial USB mouse is

connected, it can cause malfunction or damage of this device or

the connecting device.

Important

NOTICE

Installing the Controller Unit

• Do not install the controller in a location with lots of dust or

water vapor.

The controller does not have a mechanism to protect it from

dust or water. Dust or water entering the controller can cause

damage to the controller.

• Turn off the power to the controller when connecting or

removing an expansion unit, a cable, or a terminal block.

Connecting or removing the camera expansion unit, the

cable, or the terminal block while the power is being supplied

may damage the controller or peripheral devices.

• When an expansion unit is not connected, place the

connector protection cover back on the controller. Using the

controller with the connector exposed may cause damage to

the controller.

• Do not block the ventilation openings on the top and bottom

of the controller. If the vents are blocked, heat will

accumulate inside the controller and can cause a system

failure.

• When installing the controller on a surface, pierce holes in

the surface at the positions of the ventilation openings on the

bottom of the controller or perform similar operations to

ensure that there is ventilation from the bottom of the

controller to the top.

• If the temperature inside the control panel (temperature at

the bottom of the controller) exceeds the rating, use forced

air-cooling or increase the free space around the system to

improve ventilation until the operating ambient temperature

decreases below the rating.

NOTICE

50 mm

50 mm 50 mm

50 mm

NOTICE

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Keyence CV-X100 Series User Manual Page 3

Comments to this Manuals

Related products and manuals for Lighting Keyence CV-X100 Series