Keyence BL-180 User Manual download pdf (Page 48)

3.3 Setup Software Operating Procedure

3.3.13 Sending Settings

1. Choose Send from the menu bar. The following screen appears.

2. Set the baud rate, data bits, stop bit and parity according the BL-180’s set-

tings. The BL-180’s default settings are shown above.

3. Specify whether the parameter settings are to be saved in the EEPROM or

not. If the current settings are not saved in the EEPROM, the setup software

will start with the previous settings when the power is turned on again.

4. After setting the communication parameters, click on OK. Data transmission

will begin. If a communication error occurs, the following message will

appear.

If you are not sure of the communication parameter settings of the BL-180,

turn ON the BL-180’s power switch before executing data transmission, and

set the communication parameters as shown in step 1.

* The BL-180’s communication parameters are set as shown above for 5 seconds

after the power is turned ON. (see page 46.)(See p. 58 of the Users’ Manual.)

5. If the setup software is normally exited, it will return to the main setting

screen.

3.3.14 Version Display

1. Click on Info on the manu bar.

2. The following screen appears, where you can conﬁrm the version of this

setup software.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 108 109

No comments

Keyence BL-180 User Manual Page 48