Keyence BL-180 User Manual download pdf (Page 61)

4.3 Command Communication

4.3.4 Response Error Code

When an incorrect command is sent to set parameters, the BL-180 sends back

data indicating the cause of the error (error code). For the commands correspond-

ing to the error codes, see the error code column given in the table on the follow-

ing pages.

4.3.5 Description of Parameter Setting Commands

Saving/Initializing Settings/Quitting Setting Mode

Error code Cause of error

00 Undeﬁned command.

01 Command format is incorrect.

02 Nothing corresponds to the number in the command.

03 “m” value (codes 1 to 4) is other than 0 to 3.

“Bar code type setting command” was not sent ﬁrst.

Sending “No. of readable digits setting command” is invalid

for JAN code.

05 The number in the command is too long.

06 “hhh...” data is too short.

07 “n” value is not 0 or 1.

08 “n” value is exceeding the setting range.

09 “nnn” or “nn” value is exceeding the setting range.

10 “hhh...” is not speciﬁed in HEX (hexadecimal) code.

11 “hhh...=FF” cannot be set.

“hhh...” or “aaa...” contains more than the speciﬁed number

of characters.

13 Characters of “aaa...” are invalid.

Data in the EEPROM may be damaged. Perform initial

setup.

Error in the area storing initial settings.

Settings are automatically initialized.

17 \ is not followed by !, ? or \ in preset data. (See page 70.)

18 Two !s exist in preset data. (See page 20.)

99 The BL-180 may malfunction. Contact KEYENCE.

Function Command being sent

Respons

Description

Error

Code

Saves settings in the EEP-

ROM.

SAVE OK See page 51. -

Initializes settings. DFLT OK Returns to the default-settings, and saves the set-

tings in the EEP-ROM.

00,05

14,15

Quits the setting mode. SEND OK See page 51. -

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 108 109

Comments to this Manuals

No comments

Keyence BL-180 User Manual Page 61

Comments to this Manuals

Related products and manuals for Sensors Keyence BL-180