Keyence DL-CL1 User Manual download pdf (Page 26)

2-10

Connection and Configuration

- CC-Link Compatible Network Unit DL-CL1 User’s Manual (SK-1000) -

2-3

Configuring the Data Link

Use the following configuration procedures for connecting the DL-CL1 to the CC-Link

system.

This manual covers only the functions and settings of a CC-Link mas-

ter station which are required for communication with the DL-CL1.

For the functions and settings related to the communication between

the CC-Link master unit and CPU unit, refer to the manuals shipped

with your master unit or CPU unit.

To connect the DL-CL1 to the CC-Link master unit, it is necessary to configure the

slave attribute and memory allocation settings.

Slave attribute settings

You can also configure the settings by importing a CSP file into the software for the

master unit (ladder programming software or CC-Link configuration software).

The CSP file can be downloaded from the KEYENCE web site:

http://www.keyence.com

Memory allocation settings

In order to exchange data between the DL-CL1 and CC-Link master station, configure

the memory allocation settings using the software for the master station (ladder

programming software or CC-Link configuration software).

Where multiple slave units are connected, the memory allocation for each

slave unit is done automatically based on the specified starting address.

The allocation information for each slave unit can be checked using the

CC-Link configuration software.

Use th

e followi

ng procedures to configure the data link of the DL-CL1.

Point

Configuring the Master Station

Reference

Configuring the DL-CL1

Operating mode setting switch

Transmission rate

setting switch

Station number

setting switch

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 77 78

No comments

Keyence DL-CL1 User Manual Page 26