Keyence IV Series User Manual download pdf (Page 25)

3-3

- IV Series User’s Manual (Field Network) -

Cyclic communication setting method

This following explains the setting method when

using the cyclic communication.



To control the IV series using the EtherNet/IP

communication, select [Network connection] for

the sensor connection setting. When connected

directly, the eld network settings will be greyed

out and disabled.



If you have modied the protocol settings, the

connection with the sensor will be terminated

and then restarted.

Setting the IV series

You can congure the following settings for the IV

series using the monitor (IV-M30) or IV-Navigator

(IV-H1).

When settings on the monitor (IV-M30)

Set the eld network settings of the sensor to

[EtherNet/IP].

Tap the [Sensor Advanced] button on the

Sensor Setup Menu screen.

Tap the [Environmental] button, and then

the [Adv. Network Settings] button.

Tap the [Settings] button in the “Field

Network”.

Select [Ethernet/IP] for the protocol.

To enable the handshake control, select

[Enable].



When the protocol is set as [Disable],

this setting item is shaded and cannot be

selected.



When the data handshake control is set

as [Enabled], the status result will not be

updated until [Result acquisition complete

notice] (“Address2, Bit0” of Output Assembly)

is input.

“Operating procedure of the cyclic

communication” (Page 3-26)

After the setting is completed, tap the [OK]

button.

Cyclic communication

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 109 110

Comments to this Manuals

No comments

Keyence IV Series User Manual Page 25

Comments to this Manuals

Related products and manuals for Sensors Keyence IV Series