Keyence SL-V Series User Manual Page 127
- Page / 168
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
6-3 Center Indicator
6-9
Indicators
6
SL-V-M-NO6-E
Built-in indicator mode
The following procedure applies only when the multi-function type cable is used.
See "Cables" (page 1-4)
Both the wait input (violet wire on the transmitter) and the override input (red/black wire on the receiver)
must be used.
See "Wait Input Function" (page 2-16)
See "Override function" (page 2-45)
Red light : Wait input ON
Green light : Override input ON
Green light : Both override and wait input ON
Light OFF : Both override and wait input OFF
(1) Turn ON the power to the SL-V.
(2) Disconnect the interlock mode selection input (pink wire on the transmitter), turn OFF muting input 1
(light blue wire on the receiver) and muting input 2 (light blue/black wire on the receiver), and then
turn ON the power to the SL-V again.
(3) To externally control the center indicator: Turn ON the override input (red/black wire on the receiver)
To initialize: Turn OFF the override input (red/black wire on the receiver)
(4) Turn ON the muting input 1.
(5) Turn ON the muting input, and then turn OFF the muting input 2. You must repeat this action four
times.
(6) Turn OFF the muting input 1.
(7) Turn ON the muting input 2.
(8) Turn ON the muting input 1, and then turn OFF the muting input 1. You must repeat this action three
times.
(9) Turn OFF the muting input 2.
(10) If these procedures are performed correctly, bar LED No. 3 on the receiver should light up green.
(11) Turn OFF the power to the SL-V, and then the interlock mode selection input (pink wire on the trans-
mitter) must be wired.
See "Interlock Function" (page 2-7)
The muting input or override input should be wired as necessary.
See "Muting function" (page 2-29)
See "Override function" (page 2-45)
(12) Turn On the power to the SL-V.
Time chart when externally controlling the center indicator
The interlock mode selection input (pink wire on the transmitter) must be disconnected.
4.5 s min.
Override input
The override input can be
ON or OFF after this point.
40 ms min.
40 ms min.
1 s min.
A
AAAA
AA
AAAA
ON
OFF
Muting input1
ON
OFF
Muting input2
ON
OFF
ON
OFF
SL-V power supply
A:20 ms min.
AAA
- SL-V Series 1
- Introduction 2
- Safety Precautions 3
- Precaution on use 4
- Operators 4
- Environment of use 4
- Target machine 4
- Installation 5
- Circuit design and wiring 6
- Testing and maintenance 7
- Standards and regulations 8
- Table of Contents 9
- Chapter 4 Wiring 10
- Chapter 5 Optical Alignment 11
- Chapter 6 Indicators 11
- Appendix 12
- Before Use 13
- Checking the Package Contents 14
- 1-2 Options 15
- Hexagon socket bolt 15
- (M5, length: 6 mm, width 15
- (For mounting to the unit) 15
- Unit connection cable 16
- Junction cable 16
- Extension cable 16
- Cable combination example 17
- Series connection cable 18
- Cable length specification 18
- Protection bar 19
- SL-V Configurator (SL-VH1S) 20
- Upload configuration 21
- Download configuration 21
- Create/Save configuration 21
- Monitor light intensity 21
- 1-3 Part Description 22
- Part Description 23
- Functions and Features 25
- Cable Selection and Function 26
- Simple function type 27
- Multi-function type 27
- 2-2 Self-diagnosis Function 28
- Self-diagnosis Function 29
- 2-3 Series Connection 30
- 2-4 Interlock Function 31
- Configuration 32
- Interlock Function 33
- Interlock-reset-ready output 35
- Time chart 36
- 2-5 AUX (Auxiliary) Output 38
- 2-7 Wait Input Function 40
- 2-8 State Information Output 42
- State Information Output 46
- How to change the mode 48
- Making changes on the SL-V 48
- 2-9 Alert Output 49
- 2-10 Clear/Blocked Output 51
- SL-V-M-NO2-E 53
- Wiring for muting device 54
- Muting lamp wiring 54
- Limitations 54
- Muting bank function 56
- Reference 57
- Password setting 58
- Number 5 6 7 8 9 59
- Changing the password 60
- Steps (2) to (8) 62
- Steps (9) to (12) 62
- Steps (13) to (18) 62
- Steps (19) to (22) 62
- Entering the password 63
- Wiring 70
- 2-12 Fixed Blanking 72
- 2-13 Reduced Resolution 73
- OSSD is ON 73
- OSSD is OFFOSSD is ON 73
- 2-14 I/O Monitoring Function 74
- I/O Monitoring Function 75
- Correct Installation Method 78
- Safe Safe 79
- Dangerous 79
- 3-2 Safety Distances 80
- (2.76") or less 81
- Example 2 :ANSI B11.19-2010 82
- Detection 83
- S mm (inch) 83
- Series Connection 84
- 3-5 Cable Connections 87
- Cable Connections 88
- J (OP-83180) 91
- L-shaped mounting bracket 92
- Wiring the muting inputs 100
- Time chart 100
- Transmitter 100
- Workpiece 101
- Receiver 104
- Switch A2Switch A1 105
- Explanation 106
- Installation to a Machine 108
- SL-V-M-NO3-E 108
- SL-V-M-NO4-E 109
- Power supply 110
- 4-2 I/O Circuit Diagram 111
- Cable Color and Pin Position 112
- 4-4 Examples of Wiring 113
- 4-4 Examples of Wiring 114
- Optical Alignment 117
- 5-1 Optical Alignment 118
- Indicators 119
- Indication pattern 121
- During lockout condition 122
- 6-2 Function Indicators 123
- 6-3 Center Indicator 124
- Built-in indicator mode 125
- State indicator mode 125
- When setting on the SL-V unit 126
- Built-in indicator mode 127
- Center Indicator 128
- Specifications and Dimensions 129
- 7-1 Model 130
- 7-1 Model 131
- 7-2 Specifications 134
- Response time (OSSD) 135
- Current consumption 136
- 7-4 Dimensions (SL-VF/VH/VL) 137
- SL-VF Units: mm 138
- SL-VH Units: mm 138
- SL-VL Units: mm 139
- 7-4 Dimensions (SL-VF/VH/VL) 142
- Dimensions (SL-VF/VH/VL) 143
- Units: mm 143
- Back mounting Side mounting 143
- Protection bar 146
- ReceiverTransmitter 147
- Transmitter Receiver 147
- SL-VFM 148
- SL-VHM 148
- SL-VLM 151
- Dimensions (SL-VFM/VHM/VLM) 152
- A-1 Troubleshooting 154
- LED bar indicator 154
- Function indicator 154
- Troubleshooting 155
- A-2 Checklist 160
- Checklist 161
- Revision History 166
- E 1101-3 167
Related products and manuals for Lighting Keyence SL-V Series
Lighting Keyence SL-VH1S User Manual
(60 pages)
(60 pages)
Lighting Keyence SL-VHS Series User Manual
(10 pages)
(10 pages)
Lighting Keyence SL-C Series User Manual
(54 pages)
(54 pages)
Lighting Keyence SL-CHG Series User Manual
(54 pages)
(54 pages)
Lighting Keyence SL-CHS Series User Manual
(54 pages)
(54 pages)
Lighting Keyence SL-R11 User Manual
(42 pages)
(42 pages)
Lighting Keyence SL-R11E User Manual
(46 pages)
(46 pages)
Lighting Keyence SL-R12EX User Manual
(76 pages)
(76 pages)
Lighting Keyence SJ Series User Manual
(1 pages)
(1 pages)
Lighting Keyence SJ-H Series User Manual
(14 pages)
(14 pages)
Lighting Keyence SJ-HA Series User Manual
(12 pages)
(12 pages)
Lighting Keyence SJ-HS/HW/HM User Manual
(2 pages)
(2 pages)
Lighting Keyence SJ-F036 User Manual
(10 pages)
(10 pages)
Lighting Keyence SJ-F300 Series User Manual
(14 pages)
(14 pages)
Lighting Keyence SJ-M400 User Manual
(14 pages)
(14 pages)
Lighting Keyence SJ-M200 User Manual
(16 pages)
(16 pages)
Lighting Keyence SJ-M201 User Manual
(16 pages)
(16 pages)
Lighting Keyence SJ-M300 User Manual
(14 pages)
(14 pages)
© 2020, manymanuals.com. All rights reserved. | 1.063 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals