Keyence IV Series User Manual download pdf (Page 62)

5-4

- IV Series User’s Manual (Field Network) -

Data I/O communication setting method

When setting by IV-Navigator (IV-H1)

Set the eld network settings of the sensor to

[PROFINET].

Open the sensor expansion settings screen.

Select the [Device settings] tab, and then

click the [Settings] button under [Field

network].

Select [PROFINET] in [Protocol] for the

eld network.

Tick the checkbox if you wish to enable the

data handshake control.



If the protocol is set to [Disabled], the

settings will be greyed out and disabled.



If data handshake control has been set

to [Enabled], the status result will not be

updated until [Result acquisition complete

notice] (“Address2 Bit0” of Command Control)

is input.

“Operating procedure of the data I/O

communication” (Page 5-32)

When you have nished conguring the

settings, click the [OK] button.

You will return to the sensor expansion settings

screen.

Click the [OK] button.

You will return to the main screen of [Setting].

Data I/O communication

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 109 110

No comments

Keyence IV Series User Manual Page 62